Half-Pint Sharps Mount Bases - Model HPMOUNTSET

These are replacement bases for the short scope model bases. The short scopes are included with bases drilled for 0.825" hole spacing. Newer Half Pint Sharps models will require these bases that are drilled for 0.860" hole spacing. Set includes a rear and front mount base.
Item Number ACC/HPMOUNTSET
$28.00

Availability: In stock

 
These are replacement bases for the short scope model bases. The short scopes are included with bases drilled for 0.825" hole spacing. Newer Half Pint Sharps models will require these bases that are drilled for 0.860" hole spacing. Set includes a rear and front mount base.

Customer Reviews

Proper length but................ Review by Buffaloman
Price
Value
Quality
These bases were the only non-custom mounts that match the new Chiappa Baby Sharps pre-drilled scope mounting holes. I purchased a Hi-Lux 6 X scope to try out on my Sharps. The original Hi-Lux bases were too short to fit the holes. However these bases had two machined set screw types, one different on one side, another on the other. The Taylor bases only had the dimple set screw machined into the base. The other side was only the sharp side of the base( inspect the photo above). The set screw did not fit the dimpled set point so I had to use the sharp pointed side, only a few thousandths of contact. The bases are also curved to match a round barrel so the bottom rests on the two thin rails formed by the curve pushing down on the flat barrel. The Taylor rep said they have done this on all the flat barreled rifles and it worked fine. Since mine is a 17 Hornet , i don't expect an issue but if I was shooting a 45-70 the recoil would be much greater.

I have yet to fire the rifle with the scope mounted but I am hoping everything will be OK. There could be better coordination between Chiappa and the retailers to insure these minor issues can be improved.

The Taylor people should be commended in their effort to provide the necessary base. Good customer support (Posted on 9/2/2015)
No problems! Review by Greyhaven
Price
Value
Quality
The mounts and screws arrived in a timely manner, and installation was very easy, with a little shortening of the screws being necessary, as they were slightly long. The 1" Malcolm scope mounted up just fine, and a trip to the range showed everything to be working properly. My little Sharps is .44-40, and nothing shook loose in over 50 shots. Both black powder and smokeless loads grouped well, though I'm still searching for that optimum load.... (Posted on 8/12/2015)

Write Your Own Review

Write Your Own Review

  1 star 2 stars 3 stars 4 stars 5 stars
Price
Value
Quality

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Product Specs

Item Number ACC/HPMOUNTSET
Manufacturer's Suggested Retail Price $28.00